PLR64K Dante - 64 channel Dante network monitor for use with remote controller

Part no. NIX00533

Stacks Image 18
Specifically designed to allow an operator/commentator to access any two independently selectable sources on the Dante network via a simple remote control panel.  Each display shows Channel Name and provides an output meter level.  Balanced XLR outputs provide feeds to local speakers or headphones.
Perfect for on-air and live applications where critical confidence monitoring is essential

A kit consisting of three parts the PLR64 Dante, 2 Gang Wall Plate Remote controller and Remote Cable 1.5M D-sub cable. It does not include a PSU as standard but one can be purchased at extra cost

The PLR64 would normally be mounted to a wall or beneath a desk and then wired via the remote cable to the 2 gang wall plate remote controller
The remote controller allows the independent selection for each output from the incoming Dante stream. Each output displays the selected Dante channel name and output signal level on the OLED display. Channel selection is made via scrolling up/down the available Dante channels via a pair of switches for each output
Each output is presented on a 3 pin male XLR. The signal is electronically balanced and provides +21dBu for 0dBFS of signal level

Firmware updates of the PLR64 Dante are achieved via a dedicated USB micro B connector on the end panel. There is also a dedicated 3.5mm jack socket for the headphone output

Nixer Ltd understands that your privacy is important to you and that you care about how your personal data is used. We will only collect and use personal data in ways that are described here in our Privacy Policy and in a way that is consistent with our obligations and your rights under the law. If you do not accept and agree with this Privacy Policy, you must stop using our Site immediately.